Propellers
-
Prop Adapters - Sold separately.US$1.00
-
Approximately 2.25 in. diameter x 20mm pitch. This propeller works with the 7mm 3.3Ohm motor as a quiet direct drive propulsion unit. This is the stock replacement prop for the Sky Buddy RTF model. Prop 57mm x 20mm prop. 1mm ID bore shaft. Weight is 0.5 gms.US$1.49 As low as: US$1.24
-
Prop - EP-4040 (102mm x 102mm) 4mm Bore 1.09gUS$1.50 As low as: US$1.00
-
Prop - EP-6030 (152mm x 76mm) 3mm Bore 2.18gUS$1.50 As low as: US$1.00
-
Prop EP-3030 (82mm x 76mm) 1.5mm Bore 0.69gUS$1.50 As low as: US$1.00
-
Prop - EP-5030 (127mm x 76mm) 4mm Bore 1.49gUS$1.50 As low as: US$1.00
Out of stock
-
Prop - EP-4530 (114mm x 76mm) 4mm Bore 1.25gUS$1.50 As low as: US$1.00
Out of stock
-
Prop EP-4025 (102mm x 64mm) 4mm Bore 1.25gUS$1.50 As low as: US$1.00
Out of stock
-
Prop - EP-5043 (125mm x 110mm) 4mm Bore 1.55gUS$1.50 As low as: US$1.00
Out of stock
-
Prop EP-3020 (82mm x 50mm) 1.5mm Bore 0.94gUS$1.50 As low as: US$1.00
-
Prop - EP-4540 (114mm x 102mm) 4mm Bore 1.34gUS$1.50 As low as: US$1.00
-
These Prop Adapters enable you to fit GWS and other props with 4mm bore to 1mm, 0.047'', and 1.5mm shafts. 2 of each type, 4mm - 1mm, 4mm - 0.047'', and 4mm - 1.5mmUS$3.00
-
This is the original Tri-Turbofan Blimp Propeller. As luck would have it, this prop works well on our 7mm coreless motors. 65mm 1mm Bore. Weight is 0.05g Great for use on Modified MCPX Heli's.US$3.25 As low as: US$1.00
-
As used on the Micro Spitfire, Micro Messerschmitt 109 and Micro Butterfly Plastic Prop 32mm diameter, 0.69mm bore to fit 4mm motor (shaft is 0.7mm press fit). 0.055g. Based on Martin Newell's good design this prop is matched well to our 4mm X 11mm 13 Ohm motor.US$3.89
-
Great little Propeller, Great for use on our GB03 or GB04 gearboxes. The prop is bored with a 0.98mm shaft hole. The weight is 0.85 GramUS$3.89
Compare Products
You have no items to compare.
My Cart
You have no items in your shopping cart.
